USB TO I2C INTERFACE MODULE DRIVER
Open source Python library (Windows, MacOS, Linux) Native Linux support (compatible with kernel driver 'i2c-tiny-usb') Wide signal voltage range (input high level: 2. 10pcs AT24C02 Module I2C Interface IIC EEPROM Storage Module Intelligent Car. It aims to easily control I2C slaves with highly portable code. CH341T V3 2 IN 1 Module 3.3V 5V USB to I2C IIC UART USB to TTL Single-Chip. Integrated +3. The Devantech USB to I2C Interface Module is a low cost USB to I2C module, with a simple command set, and interfacing to any I2C device. I2C-MP-USB - USB to I2C Interface I2C-MP-USB is a interface to connect I☬ devices via USB to a host system.
USB TO I2C INTERFACE MODULE SERIAL
0 Evaluation boards are only intended for device evaluation and not for production purposes. Use the S-Series for serial and TTL, the I-Series for I2Cor the U-Series for USB. Its functionality has been enhanced in the updated firmware (v15.12) provided by Fred PE0FKO and is in four areas: It enables control of the Automatic Band Pass Filter board on the Lite + Xtall RX V9.0. and a piece of heat shrink to cover the USB I2C board. USB Power Configurations supports bus-powered, self-powered and bus-powered with power switching USB-to-I2C Interface Dongles USB-SMBUS-CABLEZ, USB-5PSMBUS-CABLEZ Rev. an 8-pin plug for the I2C interface to the PIC socket on the application board. Up to 3.4MHz, high-speed mode, I2C supportedĮntire USB protocol handled on the chip, no USB specific firmware programming requiredįully integrated 2048 byte multi-time-programmable(MTP) memory storing device descriptors and CBUS I/O configurationįully integrated clock generation with no external crystal required plus optional clock output selection enabling a glue-less interface to external MCU or FPGAĥ12 byte receive buffer and 512 bytes transmit The UM FT200XD is a breakout board that converts USB Full-Speed to I2C. The USB-I2C module provides a complete interface between your PC and the I2C bus. The module is self-powered from the USB cable. The module is an I2C master only, not a slave. USB to I2C Professional is a general-purpose I2C and SPI interface tool that allows a user to communicate with any I2C or SPI slave devices. USB-to-I2C includes the USB-based hardware and Windows software and driver that is compatible with 64-bit versions of XP, Vista, Windows 7, Windows 8, and Windows 10.
0 kommentar(er)
